Hi everyone

I put in my CI module ( using a funcard 6) matrix revolutions the firmware neo v.3.07 after a zapping to ABsat my module is not recognized by my receiver a Telesystem TS 4.4c I think I broke my cam>-(....... can anybody help me? bye

In and out with modul...and what happens...?
reset and restart your stb...and what happens...?
sometimes it reinitialize on some channels/systems...
if nothing....
Then try to put another soft into modul and see how it works in your stb...maybe there is a conflikt between receiver software,some systems and modul...
if there is...so you need to discover which way it works best,how to change channels/systems that modul remains recognized...
Maybe you shoukd look at stb section if there is possible to update your stb...
Good luck...:-) :-P :-)

Hi everyone

I put in my CI module ( using a funcard 6) matrix revolutions the firmware neo v.3.07 after a zapping to ABsat my module is not recognized by my receiver a Telesystem TS 4.4c I think I broke my cam>-(....... can anybody help me? bye

Hello.

The firmware that you used was not meant for revolutions, but for reborn.

Your cam is not broken, its just unprogrammed. To reprogram it you'll need a CAS interface, since it's not updatable with funcards. After you reprogram it, it should work again.

Happens to me lots of times !
César